Taylor, Monroe E a écrit :
Please note that there was no grub.conf file.
The boot loader used is syslinux. Grub is not used.
I booted as normal and checked the /boot directory and it contains
-rwxr-xr-x 1 root root 2227280 2009-06-18 12:57 vmlinuz-22.214.171.124-78.2.56.fc9.i686
-rwxr-xr-x 1 root root 2269712 2009-06-18 12:45 vmlinuz-126.96.36.199-78.2.56.fc9.i686.PAE
This boot directory is located inside the compressed image, so the
syslinux bootloader cannot use it. The kernel image in /boot is not used
to boot the liveCD. It is used in (at least) two cases:
- when you perform a hard drive installation from the running liveCD
- at build time, to be copied into syslinux/ (I guess)
Searching the list archive for "kernel" will help. See for instance this:
Can anyone tell me what I must do in order to boot the PAE kernel
the live USB? This is a critical issue for me so any and all
assistance is greatly appreciated.
You can try to move the kernel outside of the compressed image, but I do
not promise this will be enough. From the runing liveCD try something
yum install kernel-PAE
mount -o remount,rw /mnt/live
mv /boot/vmlinux-PAE /mnt/live/syslinux/
Then edit syslinux/syslinux.cfg and reboot. And cross fingers.
If this does not work, you will have to understand the build process
better in order to fine-tune it. The list archive will help.