Hello,

We have upgraded to RHQ v4.13.1 from v4.11.0 a few days ago. We also went from a 3 node storage cluster to a 5 node storage cluster. Each node runs on a separate server.

When we were starting the RHQ server instances, we encountered an issue with the replication factor, as ours was set to '1' on the sys auth table, and the rhq table as well (for 1 or 2 RHQ server instances). We made the change to the replication factor to '2'. When we started the instances back up, the storage node status showed 'joining' for 3 out of the 5 nodes. The other 2 showed 'normal'. We checked the storage nodes, which are functioning just fine with no issues. We tried to connect with the RHQ CLI and run cluster maintenance to see if that would change the status in the GUI. No such luck. But again, the nodes are running just fine on the servers as indicated by the logs, etc. How can we change this status to 'normal'? Anything we can do in the GUI or run via the CLI aside from cluster maintenance?

Regards,

Barry Barnett Enterprise Queuing Services | (QS4U) Open Queuing Services Wells Fargo Cell: 803-207-7452