On Thu, 2009-04-30 at 11:23 +0200, Ján ONDREJ (SAL) wrote:
On Thu, Apr 30, 2009 at 10:18:11AM +0100, Mark McLoughlin wrote:
> On Wed, 2009-04-29 at 11:58 +0200, Ján ONDREJ (SAL) wrote:
> > Hello,
> > after my rawhide installation was corrupted, I planned to install a fresh
> > Fedora11-Preview in virt-manager. Everything worked well, just GRUB has been
> > not installed.
> I think the cause of this was actually a generic grub/anaconda issue -
> I'm sure I've seen other reports of grub failing with F11 virt preview.
> I think it's been known to hang in the "installing bootloader"
> step? I can't find any references now, anyone else seen it?
Installation worked well, just after installation an reboot qemu only shows:
Booting from Hard Disk ...
and nothing else. :(
Okay, I've just tried an F11-Preview install and it worked for me, grub
installed just fine.
> > I can't fix this by running some commands in rescue
> > My attempts are here:
> > sh-4.0# df /boot
> > Filesystem 1K-blocks Used Available Use% Mounted on
> > /dev/vda1 198337 13573 174524 8% /boot
> > My root partition is /dev/vda1, so my root disk is /dev/vda (paravirtualized
> > disk).
> > sh-4.0# grub-install /dev/vda
> > expr: non-numeric argument
> > /dev/vda1 does not have any corresponding BIOS drive.
> With the fix (i.e. grub-0.97-50.fc11) for:
May be this will help, but I can't test it now.
No, it won't help the problem you saw where anaconda didn't install the
bootloader because anaconda/booty doesn't suffer from this grub-install
issue ... it just runs:
Note, anaconda/booty doesn't suffer from the grub-install problem
because it does:
Running... ['/sbin/grub-install', '--just-copy']
Running... ['/sbin/grub', '--batch', '--no-floppy',
GNU GRUB version 0.97 (640K lower / 3072K upper memory)
[ Minimal BASH-like line editing is supported. For the first word, TAB
lists possible command completions. Anywhere else TAB lists the possible
completions of a device/filename.]
grub> root (hd0,0)
Filesystem type is ext2fs, partition type 0x83
grub> install --stage2=/boot/grub/stage2 /grub/stage1 d (hd0) /grub/stage2 p
> you need to actually pass it the device map:
> $> grub --device-map=/boot/grub/device.map
It's not default?
No device.map is used by default. And AFAIK, you need one with virtio
because the BIOS doesn't know anything about the drive.